Файл:AD607.pdf

Материал из РадиоВики - энциклопедии радио и электроники
Перейти к: навигация, поиск
Ссылка на страницу индекса

a FEATURES Complete Receiver on a Chip: Monoceiver™ Mixer –15 dBm 1 dB Compression Point –8 dBm Input Third Order Intercept 500 MHz RF and LO Bandwidths Linear IF Amplifier Linear-in-dB Gain Control MGC or AGC with RSSI Output Quadrature Demodulator On-Board Phase-Locked Quadrature Oscillator Demodulates IFs from 400 kHz to 12 MHz Can Also Demodulate AM, CW, SSB Low Power 25 mW at 3 V CMOS Compatible Power-Down Interfaces to AD7013 and AD7015 Baseband Converters

Low Power Mixer/AGC/RSSI 3 V Receiver IF Subsystem AD607 PIN CONFIGURATION 20-Lead SSOP (RS Suffix)

FDIN 1

20 VPS1

COM1 2

19 FLTR

PRUP 3

18 IOUT

LOIP 4 RFLO 5

17 QOUT

AD607

16 VPS2

TOP VIEW RFHI 6 (Not to Scale) 15 DMIP GREF 7

14 IFOP

MXOP 8

13 COM2

VMID 9 IFHI 10

12 GAIN/RS 11 IFLO

APPLICATIONS GSM, CDMA, TDMA, and TETRA Receivers Satellite Terminals Battery-Powered Communications Receivers

GENERAL DESCRIPTION

The AD607 is a 3 V low power receiver IF subsystem for operation at input frequencies as high as 500 MHz and IFs from 400 kHz to 12 MHz. It consists of a mixer, IF amplifiers, I and Q demodulators, a phase-locked quadrature oscillator, AGC detector, and a biasing system with external power-down. The AD607’s low noise, high intercept mixer is a doublybalanced Gilbert cell type. It has a nominal –15 dBm input referred 1 dB compression point and a –8 dBm input referred third-order intercept. The mixer section of the AD607 also includes a local oscillator (LO) preamplifier, which lowers the required LO drive to –16 dBm.

The I and Q demodulators provide inphase and quadrature baseband outputs to interface with Analog Devices’ AD7013 (IS54, TETRA, MSAT) and AD7015 (GSM) baseband converters. A quadrature VCO phase-locked to the IF drives the I and Q demodulators. The I and Q demodulators can also demodulate AM; when the AD607’s quadrature VCO is phase locked to the received signal, the in-phase demodulator becomes a synchronous product detector for AM. The VCO can also be phase-locked to an external beat-frequency oscillator (BFO), and the demodulator serves as a product detector for CW or SSB reception. Finally, the AD607 can be used to demodulate BPSK using an external Costas Loop for carrier recovery.

The gain control input can serve as either a manual gain control (MGC) input or an automatic gain control (AGC) voltagebased RSSI output. In MGC operation, the AD607 accepts an external gain-control voltage input from an external AGC detector or a DAC. In AGC operation, an onboard detector and an external averaging capacitor form an AGC loop that holds the IF output level at ± 300 mV. The voltage across this capacitor then provides an RSSI output.

REV. 0 Information furnished by Analog Devices is believed to be accurate and reliable. However, no responsibility is assumed by Analog Devices for its use, nor for any infringements of patents or other rights of third parties which may result from its use. No license is granted by implication or otherwise under any patent or patent rights of Analog Devices.

© Analog Devices, Inc., 1995 One Technology Way, P.O. Box 9106, Norwood. MA 02062-9106, U.S.A. Tel: 617/329-4700 Fax: 617/326-8703


1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24
Перейти на страницу


Исходный файл(2550 × 3300 пикселей, размер файла: 511 КБ, MIME-тип: application/pdf, 24 страницы)

Importing file

История файла

Нажмите на дату/время, чтобы просмотреть, как тогда выглядел файл.

Дата/времяМиниатюраРазмерыУчастникПримечание
текущий15:48, 19 мая 2014Миниатюра для версии от 15:48, 19 мая 20142550 × 3300, 24 страницы (511 КБ)Maintenance script (обсуждение)Importing file
  • Вы не можете перезаписать этот файл.

Нет страниц, ссылающихся на данный файл.

Метаданные